<--Back to page 31 | pg 32 | Next to page 33-->

Mike, from F.AC. says, This is my 98k Gewehr rework restored to original style w/ new barrel, and stock and handguard from FAC Gunsnstuff. It took about 8-9 hours to fit the metal to the wood (at a methodical pace, and hand tools), and another 2-3 for finishing. I used cherry stain and satin polyurethane spay for the finish.

Casey Says- My project is finally done, here are its specs:
Action: Mauser M48
Barrel: Schilen stainless #3 match grade in 7mm-08
Stock: Richard's Micro-fit Monte Carlo black laminate
Scope: Swift 3-9x40
Rings: Warne quick release
Bolt handle was turned down, action bead blasted and matte blued, and a timney delux trigger installed.

Richard M says- I just finished this rhineland arms conversion on a
vz-24. The stock is my own custom, lighten the trigger pull, drilled and tap the receiver, added a red dot and blued the barrel. Thanks for a great site.

Jeff H. Says- Here is a VZ24 action I picked up for my son. I put an Adams&Bennett 24" bull barrel in .308Win and put this in a Fajen Walking Ace Varminter Stock that I used Arrow'd wood finish to finsih with. I put on a commercial hinged floor plate and a Sunny Hill bolt shroud. I also cut the handle off the bolt and replaced it with a Wheeler handle that is finished with Lauer's flat black paint. I jeweled the bolt as well as the extractor and put on a Bold optima trigger set at 3 1/2 lbs. The first day out, it shot a 15 shot group at around 1 1/2". It took around 30 shots to get to smooth out. I hope in the coming months it gets even better.